30 Mar 2010

Change to 500kHz ATU

This evening, as an experiment, I rewound the tapped coil on on ferrite rod based table-top ATU for 500kHz using 0.56mm enamelled wire rather than 0.2mm. The antenna current was up by (at most) 20%,  but on-air it made no difference with reports on 500kHz from M0BMU being the same as before. Before I put away my 500kHz kit for the summer I may try an L vertical with a 15m long horizontal top as I have access to a nice tree in my neighbour's garden which would provide a convenient support for the far end.

No comments: