6 Sept 2012

FLEX-6700R hype?

Just read this on a UK supplier's website:
The FLEX-6700R™ Signature Series receiver is based on a new hardware architecture and SmartSDR™ software platform.  This hardware uses Digital Down Conversion (DDC) to convert from RF to digital.  The FLEX-6700R uses two Spectral Capture Units™ (SCU) for the RF to digital conversion and an ultra high performance on-board signal processing and control system to perform demodulation, filtering, and audio stream management.  The result is incredible receiver dynamic range and received signal clarity.
The FLEX-6700R model receiver utilizes two SCUs for reception from 0.33 to 77 MHz plus 135 to 165 MHz and the ability to create up to 8 full featured independent SLICE RECEIVERS.  Optimized preselector filters can be selected for the ham bands for greater out of band rejection.
SmartSDR is the “ecosystem” of the radio platform.  It organizes all the signal processing power in the radios into an advanced radio fabric.  SmartSDR understands the capabilities of each SCU and how to harness its power.  It also comprises of the “presentation layer” or GUI client that the user interacts with.  The FLEX-6700 utilizes an Ethernet connection for high-speed “driverless” access to the graphical user interface (GUI).
Now I know there are people around with too much money and there are some applications when a very good receiver may be of benefit, but would YOU spend £4799.94 on one? This is just the receiver remember! No thanks. I'll continue to build simple rigs for a few pounds and accept their limitations.

4 comments:

Paul Stam PAØK said...

No way... I agree with the last sentence.

Dick said...

Ditto!

Anonymous said...

GBP 4799.94 = USD 7661.18

You gotta be kidding... Flex-Radio and Elecraft need to join up.

Anonymous said...

Reports of the receiver are exceptional.

Given that the capabilities of this UKP 4400 rx would cost circa UKP 110,000+ in other offerings, this is am awesome machine.

73

Steve
K9ZW

Blog: http://k9zw.wordpress.com