 |
| Rev C Transverter (one correction: o/p LPF cap 6n8, not 100n) |
Armed with the sensitivity data in the last post I have now modified my MF transverter to add the receive parts, without a preamp. I used the same scheme adopted in my old transverter to automatically switch through the 500kHz (or 472kHz) signal on receive directly to the FT817. Only 4 additional parts were needed to make it into a TX/RX transverter. As proof that the RX part is working I have just copied PA0WMR with a huge signal on OPERA Op4 with the signal passing through the transverter.
4 comments:
The mixer around T2 surprises me. It saves an expensive SBL1 !
Is the performance comparable ?
73 Ron
PA2RF
Yes it works fine Ron.
Roger, this is very encouraging to me. I have an FT100d that should work as well. I assume that I could also use my 3.900 MHz FT243 crystal and tune my radio to a freq that is 472 higher (or lower) to tx on 600m. Do you see any problem with using ur circuit this way? Neil in Utah, de w0yse/7
Neil, yes it will work with crystals a few MHz either side of the frequency I used (to get the new band to appear within an unmodified FT817 tuning range).
Still working on the design folks so check back periodically.
Post a Comment