9 Jun 2013
PY1RO on 6m CW - real DX reception!
The magic band (6m) is full of surprises. I came into the shack this evening after gardening most of the day up at our new bungalow to hear some signals on 6m WSPR. Rather than decode, I tuned down to the DX portion of the band to hear PY1RO (GG87lb Brazil) coming through at 559 on CW on 50.108MHz at a distance of 9369km. I was copying him on the V2000 vertical and my FT817 with a long lossy feeder. A few minutes later and he had faded out completely! Although I called him a couple of times, I did not break the pile-up, not that I was really expecting to, HI. Still, it was good to hear my best DX on the band in some years. At this time of year the propagation is more likely to be multi-hop Es rather than TEP I believe. Here is a video of PY1RO on 6m (not this occasion though).
Labels:
6m,
magic band,
py1ro
8 Jun 2013
G4HJW "Finningley" Optical Transceiver kit
The G4HJW optical transceiver kit |
Exactly when I'll get my kit built I'm not sure but it will be good to have one of these available for optical line-of-sight tests in the autumn. Once assembled, I shall be looking for some 2-way optical QSOs beyond the 10km speech contact I achieved with my own kit last summer. In East Anglia, the issue is finding some hills to allow long line-of-sight paths.
Bernie is, I understand, considering putting together a further batch of these kits, which make a good introduction to nanowave communications. In addition to these electrical kits, all that is needed is a microphone, headset and some simple optics than can be built for a few pounds.
See http://www.earf.co.uk/nanotrx.htm for more details
Labels:
finningley,
g4hjw,
kit,
nanowave,
optical,
transceiver
Yaesu price drop
http://www.universal-radio.com/ |
Labels:
exchange rate,
prices,
yaesu,
yen
Playing with a ferrite rod at VLF
Just for amusement, but with a slight hope it might work, I tried resonating a LW ferrite rod coil (about 3.5mH) at 8.97kHz to see how it might perform as a miniature portable receiving loop in my earth-mode tests.
To test other antennas and VLF preamps, I first connect my 8.97kHz 5W transmitter into a resistive dummy load and check that I can detect the signal strongly some distance away locally (about 10m away only). The emissions from the cables are such that this gives me around 30-40dB S/N on Spectran with the usual settings on my 80cm loop. Switching over to the ferrite rod RX antenna it was hard to tell if a signal was there at all.
So, that's one experiment I'll close and report as a failure. Had it worked, even 10s of dB down, it might have made a magnetic field antenna that could have been deployed mobile. You may recall I tried /M on 8.97kHz a few months ago with my 80cm loop strapped behind the car, until someone pointed out this probably would have invalidated my car insurance and I stopped. I had vague ideas of dropping the VLF resonated ferrite rod close to the ground behind, somehow fixed from the rear bumper.
Ho hum, another idea bites the dust.
To test other antennas and VLF preamps, I first connect my 8.97kHz 5W transmitter into a resistive dummy load and check that I can detect the signal strongly some distance away locally (about 10m away only). The emissions from the cables are such that this gives me around 30-40dB S/N on Spectran with the usual settings on my 80cm loop. Switching over to the ferrite rod RX antenna it was hard to tell if a signal was there at all.
So, that's one experiment I'll close and report as a failure. Had it worked, even 10s of dB down, it might have made a magnetic field antenna that could have been deployed mobile. You may recall I tried /M on 8.97kHz a few months ago with my 80cm loop strapped behind the car, until someone pointed out this probably would have invalidated my car insurance and I stopped. I had vague ideas of dropping the VLF resonated ferrite rod close to the ground behind, somehow fixed from the rear bumper.
Ho hum, another idea bites the dust.
Labels:
8.97khz,
ferrite rod,
vlf
6 Jun 2013
Shortwave Radio Archive
Just spotted on the Southgate site that K4SWL is creating a website to archive shortwave broadcast recordings before these disappear. Already many SW BC stations have closed at least parts of their services. The HF broadcast bands are nothing like they were even 20 years ago. See http://shortwavearchive.com/ .
My shortwave radio experience started over 50 years ago listening to SW broadcast stations on a simple crystal set in my bedroom. As much as I hated the propaganda from the communist broadcasters like Radio Moscow and Radio Sofia, Bulgaria, I do miss them and their evocative interval signals.
See also https://sites.google.com/site/g3xbmqrp3/hf/interval and take a nostalgic trip down memory lane.
My shortwave radio experience started over 50 years ago listening to SW broadcast stations on a simple crystal set in my bedroom. As much as I hated the propaganda from the communist broadcasters like Radio Moscow and Radio Sofia, Bulgaria, I do miss them and their evocative interval signals.
See also https://sites.google.com/site/g3xbmqrp3/hf/interval and take a nostalgic trip down memory lane.
Labels:
interval signals,
k4swl,
shortwave
Good results with new VLF earth-mode RX system
Today I carried out a test with my new simpler RX system for VLF/LF earth-mode "through the ground" communications, testing with a 5W TX into 20m spaced earth electrodes at 8.976kHz.
The new preamp is just a single MPF102 impedance converter feeding into a small,low cost, external USB sound card (£3) that feeds my baby Asus X101CH netbook (£172) running Spectran software to display the received QRSS3 signal. The external soundcard was only needed as I didn't have a 4-pin jack to use the audio-in socket on the Asus.
Tests were carried out at the usual test sites at 1.6, 3.6 and 6km as well as one further (unsuccessful) test at 6.2km.
In all locations, decent signals were copied, even at 6km. The little Asus netbook has an SD card running Readyboost and behaved perfectly well during the tests. Now, the whole system is very simple to deploy in the field to take measurements. The preamp is only tuned by the loop and its resonating capacitors (a capacitance decade box), so the very same preamp can be used right across the VLF and LF spectrum with a suitable receiver.
Today the weather was dry and has been for around a week now. I believe signals by earth-mode are stronger after a period of dry weather as the soil conductivity is lower. Results are as good, or better, than I have ever experienced before with earth-mode at 8.976kHz.
The next test will be to repeat this test at around 1kHz and possibly lower frequencies.I also want to try WSPR and repeat the tests at much higher LF frequencies around 72-73kHz. For the latter test, I need to build a simple down converter to audio.
The new preamp is just a single MPF102 impedance converter feeding into a small,low cost, external USB sound card (£3) that feeds my baby Asus X101CH netbook (£172) running Spectran software to display the received QRSS3 signal. The external soundcard was only needed as I didn't have a 4-pin jack to use the audio-in socket on the Asus.
Tests were carried out at the usual test sites at 1.6, 3.6 and 6km as well as one further (unsuccessful) test at 6.2km.
In all locations, decent signals were copied, even at 6km. The little Asus netbook has an SD card running Readyboost and behaved perfectly well during the tests. Now, the whole system is very simple to deploy in the field to take measurements. The preamp is only tuned by the loop and its resonating capacitors (a capacitance decade box), so the very same preamp can be used right across the VLF and LF spectrum with a suitable receiver.
Today the weather was dry and has been for around a week now. I believe signals by earth-mode are stronger after a period of dry weather as the soil conductivity is lower. Results are as good, or better, than I have ever experienced before with earth-mode at 8.976kHz.
The next test will be to repeat this test at around 1kHz and possibly lower frequencies.I also want to try WSPR and repeat the tests at much higher LF frequencies around 72-73kHz. For the latter test, I need to build a simple down converter to audio.
Labels:
earth-mode,
vlf
5 Jun 2013
YouKits TJ2B SSB handheld kits on eBay
The TJ2B 4-band SSB HF handheld is available direct from China for around £176 as a kit with all the SMA components already mounted on the PCBs. See eBay item number 271195721443.
Hamshop.cz
Although I have not used them myself (yet), www.hamshop.cz has a range of interesting and useful parts and kits available for purchase by PayPal. They ship worldwide too. Check out the page in English. As far as I can see, the prices are quite reasonable too.
Labels:
hamshop.cz
Cloudbounce and scatter optical and IR tests
This morning I read a most interesting article about French cloudbounce and scatter optical tests using lasers. The article is some years old but makes a fascinating read. My own experience with clear air forward scatter at optical frequencies using relatively low powered red LEDs makes me believe that a LOT more is possible in this area. It is a bit like people saying, "UHF is only line-of-sight". Rubbish! With decent, easily built kit it is possible to copy QRP amateur signals over the horizon even at IR and visible optical frequencies.
See http://sd-1.archive-host.com/ membres/up/22679775843705539/ CBVUK.pdf
See http://sd-1.archive-host.com/
First Icom IC7100 review on eHam.net
http://www.icomamerica.com |
Labels:
ic7100
Subscribe to:
Posts (Atom)