5 Feb 2013

137kHz 30-40W TX transverter schematic

As promised, here is the schematic of the current 30-40W TX transverter for 137kHz. I have used a 10MHz crystal but a lower local oscillator frequency would be slightly better from a stability viewpoint when using narrowband modes like QRSS30 or WSP15. One choice is to use a low cost 1.843kHz crystal mixing with the driver transmitter's output at 1.979kHz. When a stable external LO source is possible e.g. a GPS disciplined oscillator, remove C7 and feed the LO into the double balanced mixer. Although an SBL-1 mixer was used an alternative, available from eBay is the ADE-1. As balance is not super critical, a home made double balanced mixer would also be possible.

For PA heatsink I just used a couple of small TO220 heatsinks in the prototype. With optimal PA matching into 50 ohms there is little heat from the PA device. A larger heatsink could prevent overheating when the antenna is mismatched. My output network was optimised for my slightly higher than 50 ohms output load presented by my earth electrode antenna.

ERP is around 30uW with my earth-electrode antenna.

Some may prefer to use capacitive coupling into the FET gate. If TR3 failed open circuit, the gate voltage would rise leading to the IRF640 failing. Hasn't been a problem so far though.

No comments: