Earth-electrode "antenna" further description

Earth-electrode "antenna" system - click to enlarge

As blog readers will know, over the years I have had great success on VLF earth-mode, LF and MF with a very simple "antenna" that the neighbours and XYL don't even realise is there. Now, if you have space for a real antenna you may well get better results with a proper antenna and ground system. However, if like me, you don't like big antennas this may be an answer, at least with modes like WSPR, JT9 and FT8. Every situation is different. At the old QTH I did not need a matching transformer at all. At your QTH you may need a different turns number or ratio. At 137kHz, 472kHz and 1.84MHz my theory is this forms a loop in the ground. With VLF utilities assisted earth-mode I think it behaves differently.

3C90 step-up transformer

Basically, the far end connects to a ground rod about 1m long in the soil. This is connected to the shack end via a wire (normal hook-up wire) that runs along the garden fence, not far off the ground. At the shack end I connect to the mains ground (please check that this is safe at your QTH as mains earths vary), although at the old QTH I used a separate ground spike (outside the shack) with the wire from the far ground spike run along the ground. Results were almost identical.

At this QTH I use a 3C90 42mm diameter toroid with 2t on the primary (connected to the rig or transverter) and a 20t secondary (connected to the "antenna"). This was empirically wound to give best match and best ERP. I hope the diagram and photo helps. The video was at the old QTH.