10m DT way off - now reset

I had an anonymous comment to tell me that my 10m beacon's DT (timing error) was over 3 seconds out. I have had this before. The cure last time was a hard reset and I have done this again, removing all power for 10 minutes and resyncing to internet time. I was still getting decodes but you must reach a point when the receiver's software cannot cope and just gives up. Hopefully this will do the trick.

By using the FT817 and PC, I can check my 10m DT myself. This means going QRT on 6m for a few minutes. I'll do this now.

UPDATE 1618z:  10m DT checked after hard reset. Now DT = -0.3secs, which is good.