The output of my TDA2003 based VLF earth-mode transmitter is around 5W into 4 ohms. The new semi-permanent earth mode "antenna" just installed measured at around 50-60 ohms resistive at 8.97kHz. I used an AC potential divider technique to check this. Today I wound a small 3C90 based transformer using the advice I got from various people yesterday and it works very well, matching the TDA2003 perfectly to the earth electrode pair. I managed to destroy my K1EL message keyer's 5V regulator (and the keyer IC too!) so a rebuild is required before I go out into the field again to do some RX measurements. All being well these new tests will start in the next few days.
My SFH213 PIN photodiodes arrived today and my 12W Phlatlight LEDs are due next week. I'd better crack on with the new VLF earth-mode tests before these arrive as I will want to try some over-the-horizon 481THz tests with the more powerful optical transmitter and more sensitive detectors.
No comments:
Post a Comment